Skin A Deer With An Air Compressor

air comThis infographic from Quincy Compressor got my attention, what do you think?

Step 1: Hang Your Deer

You start out the same way you would normally skin a deer. There are different thoughts about if it’s better to hang the deer head up or head down, but we’ve found that when you’re using an air compressor it doesn’t make a difference. Pick whichever way you’d like or are used to and hang the deer at a level where you can easily reach the whole thing.

 

Step 2: Cut A Hole

Once your deer is hanging securely, it’s time to make the first cut. Use a knife to cut a small hole in the skin that covers the deer’s thigh. This hole should be just big enough to fit the nozzle of the air compressor. Ideally you want to make it so that no air can get out once you have the nozzle in. If you find that you’ve made the hole too big you can put a piece of cloth or tape around the nozzle so it fits.

Step 3: Insert Nozzle

Next, simply insert the nozzle from the air compressor into the hole you made in the deer’s thigh. If it doesn’t fit, either make the hole larger or use tape or cloth around the nozzle to make it air tight.

Step 4: Turn On The Air

Now it’s time for the fun part. Turn on the air compressor and watch as the deer starts to puff up light a balloon! What happens is that the force of the air pushes under the skin and causes it to push itself off of the meat. The air separates the skin cleanly and neatly without causing any meat to go to waste.

Step 5: Repeat As Needed

Usually this works very well, but every once in a while there will there be parts that are still stuck. If that happens, simply cut another hole near that spot and repeat the previous steps. After doing this a couple times you’ll have the skin completely separated from the rest of the deer.

Step 6: Skin The Deer

Last, all you have to do is cut the skin along the deer’s back legs and then start to peel. The skin should be very loose from the air. Start at the top and peel the skin downward. Use a knife to cut through any spots that still might be stuck.

Then just like that, you’re done! You’ll have a perfectly skinned dear without any wasted meat.

I am looking for a few volunteers who own compressors to try it this season. Then write me a review and email, with pictures. I’ll send you a BIG DEER cap and some other cool swag.

One thought on “Skin A Deer With An Air Compressor

  1. We will give it a few attempts this season and report back, will try to video or take still photos, as well.

Comments are closed.